Artesyn MVME7100 Single Board Computer Installation and Use (June 2014) User Manual

Page 92

Transition Module

MVME7100 Single Board Computer Installation and Use (6806800E08D)

Procedure

For PIM installation, perform the following steps:

1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the

chassis as a ground. The ESD strap must be secured to your wrist and to ground
throughout the procedure.

2. Carefully remove the transition module from its packaging and lay it flat on a stable

surface.

3. Remove the PIM filler from the front panel of the transition module.

4. Slide the face plate (front bezel) of the PIM module into the front panel opening

from behind and place the PIM module on top of the transition module, aligned
with the appropriate two PIM connectors. The two connectors on the underside of
the PIM module should then connect smoothly with the corresponding connectors
on the transition module (J10 and J14).

5. Insert the four short Phillips screws, provided with the PIM, through the holes on

the bottom side of the transition module into the PIM front bezel and rear
standoffs. Tighten the screws.
Refer to the following figure for proper screw/board alignment. The example below
may not accurately represent your MVME7100.