Artesyn MVME7100 Single Board Computer Installation and Use (June 2014) - Manual (Page 53)

Controls, LEDs, and Connectors
MVME7100 Single Board Computer Installation and Use (6806800E08D) 53
3.3.3 Connectors
This section describes the pin assignments and signals for the connectors on the MVME7100.
The next table lists the standard connectors on the MVME7100 baseboard. Refer to
Figure 3-1
on page 50 for connector locations. Pin assignments for the connectors are in the following
sections. Some connectors use standard pin assignments in compliance with the VMEbus, IEEE,
PCI, and ANSI/VITA specifications. Links to these specifications are located at
Appendix B,
Related Specifications, on page 124 .
Table 3-2 Baseboard Connectors
Reference Designator Function Notes
J6 XMC Expansion 8X PCI-E to XMCSpan
J4A TSEC 1, 10/100/1000 Ethernet RJ-45
J4B TSEC 2, 10/100/1000 Ethernet RJ-45
J11, J12, J13, J14
J21, J22, J23 PMC1
PMC2 Implementing all recommended and
optional VITA32 signals except
RESETOUT#
J1 Port 0. Serial Port 1 Mini DB-9 console serial port
P1 VME five-row P1
P2 VME five-row P2 on SBC and RTM TSEC3 signals assigned to E1-1 thru E1-4
TSEC4 signals assigned to E2-1 thru E2-4
Serial ports 2-5
J2 USB Single channel upright USB connector.
USB1 on front
P4 Processor COP header
P5 Boundary Scan header