Artesyn MVME7100 Single Board Computer Installation and Use (June 2014) - Manual (Page 27)

Chapter 2
MVME7100 Single Board Computer Installation and Use (6806800E08D) 27
Hardware Preparation and Installation
2.1 Overview
This chapter provides startup and safety instructions related to this product, hardware
preparation instruction that includes default switch settings. System considerations and
installation instructions for the baseboard, PMC, and transition module are also described in
this chapter.
A fully implemented MVME7100 consists of the baseboard plus:
 Two single-wide or one double-wide PCI Mezzanine Card (PMC) slot for added versatility.
 One transition module for support of the mapped I/O from the MVME7100 baseboard to
the P2 connector.
 Up to two optional XMCspan cards.
The following table lists the things you will need to do before you can use this board and tells
you where to find the information you need to perform each step. Be sure to read this entire
chapter, including all Caution and Warning notes, before you begin.
Table 2-1 Startup Overview
Task Page
Unpack the hardware. Unpacking and Inspecting the Board on page 28
Configure the hardware by setting jumpers
on the board and RTM. Configuring the Board on page 35 and SEEPROM Address
Switch, S1 on page 86
Install the MVME7216E transition module in
the chassis. Transition Module on page 42
Install PMC module (if required). Installing Accessories on page 41
Install XMCspan module (if required). XMCspan Installation and Use (6806800H03)
Install the MVME7100 in the chassis. Installing and Removing the Board on page 46
Attach cabling and apply power. Completing the Installation on page 47
Install PIM on transition module (if required). PMC Input/Output Module on page 91
Ensure that the firmware initializes the
MVME7100 Chapter 6, MOTLoad Firmware
Initialize the board Chapter 6, MOTLoad Firmware
Examine and/or change environmental
parameters. MVME7100 Single Board Computer Programmer’s Reference