Artesyn MVME7100 Single Board Computer Installation and Use (June 2014) - Manual (Page 41)

Hardware Preparation and Installation
MVME7100 Single Board Computer Installation and Use (6806800E08D) 41
2.4.3 VME System Controller Select, S2
Positions 1 and 2 of S2 are used to select VME System Controller selection. The default is for
automatic determination of SYSCON.
If you are installing the optional MVME7216E transition module, refer to Transition Module on
page 42 for configuration switch settings.
2.5 Installing Accessories
This section describes the procedures for installing the MVME7216E transition module, PMCs,
and the XMCspan on the baseboard.
Table 2-6 VME System Controller and GA Switch Settings
Position Function Default
S2-1 VME SCON Auto
1
Auto-SCON
S2-2 VME SCON SEL
2
Non-SCON
S2-3 GAP 1
S2-4 GA4 1
S2-5 GA3 1
S2-6 GA2 1
S2-7 GA1 1
S2-8 GA0 1
1. The VME SCON MAN switch is OFF to select Auto-SCON mode. The switch is ON to select manual SCON mode which
works in conjunction with the VME SCON SEL switch.
2. The VME SCON SEL switch is OFF to select non-SCON mode. The switch is ON to select always SCON mode. This switch
is only effective when the VME SCON MAN switch is ON.