Artesyn MVME7100 Single Board Computer Installation and Use (June 2014) - Manual (Page 47)

Hardware Preparation and Installation
MVME7100 Single Board Computer Installation and Use (6806800E08D) 47
7. Verify that the MVME7100 is properly seated and secure it to the chassis using the
two screws located adjacent to the injector/ejector levers.
8. Connect the appropriate cables to the MVME7100.
To remove the board from the chassis, reverse the procedure and press the red locking tabs
(IEEE handles only) to extract the board.
2.7 Completing the Installation
The MVME7100 is designed to operate as an application-specific compute blade or an
intelligent I/O board/carrier. It can be used in any slot in a VME chassis. When the MVME7100 is
installed in a chassis, you are ready to connect peripherals and apply power to the board.
Figure 3-1 on page 50 and Figure 5-1 on page 84 show the locations of the various connectors
on the MVME7100 and MVME7216E.
The console settings for the MVME7100 are:
 Eight bits per character
 One stop bit per character
Product Damage
RJ-45 connectors on modules are either twisted-pair Ethernet (TPE) or E1/T1/J1 network
interfaces. Connecting an E1/T1/J1 line to an Ethernet connector may damage your system.
 Make sure that TPE connectors near your working area are clearly marked as network
connectors.
 Verify that the length of an electric cable connected to a TPE bushing does not exceed 100
meters.
 Make sure the TPE bushing of the system is connected only to safety extra low voltage
circuits (SELV circuits).
If in doubt, ask your system administrator.