Artesyn MVME7100 Single Board Computer Installation and Use (June 2014) - Manual (Page 89)

Transition Module
MVME7100 Single Board Computer Installation and Use (6806800E08D) 89
5.5.1 MVME7216E PMC I/O Module (PIM) Connectors (J10, J14)
PMC Host I/O connector J10 routes only power and ground from VME P2. There are no Host I/O
signals on this connector. The MVME7100 routes PMC I/O from J14 of PMC Slot 1 to VME P2
rows A and C. The MVME7216E routes these signals (pin-for-pin) from VME P2 to PMC I/O
Module connector J14. See
Table 5-6 and Table 3-8 for the pin assignments.
SPEED 10/100/1000Mb/s of Ethernet connectors
Table 5-5 Transition Module LEDs (continued)
LED Function
Table 5-6 MVME721 Host I/O Connector (J10) Pin Assignments
Pin Signal Signal Pin
1 No Connect No Connect 2
3 No Connect No Connect 4
5 +5V No Connect 6
7 No Connect No Connect 8
9 No Connect +3.3V 10
11 No Connect No Connect 12
13 GND No Connect 14
15 No Connect No Connect 16
17 No Connect GND 18
19 No Connect No Connect 20
21 +5V No Connect 22
23 No Connect No Connect 24
25 No Connect +3.3V 26
27 No Connect No Connect 28
29 GND No Connect 30
31 No Connect No Connect 32
33 No Connect GND 34