Analog Way MIDRA PLATFORM TPP Current Programmer's Guide - Manual (Page 19)

19
PROGRAMMER'S GUIDE FOR v01.02.11
3.4 TAKE : Transitioning a Preview screen onto a Program screen
3.4.1 usage
The “TAKE” action allows transitioning, for a single screen, the “Preview” content (next state) to the
“Program” (current state) using the current transition.
3.4.2 Midra™ transitions reminder
Picture modifications can be made directly on the program screen (in the “current preset”) or can be
prepared on the preview screen (in the “next preset”) and applied synchronously through the TAKE
command. The device will try to apply all preset changes in one step, using user parameters. Depending on
the complexity of preset changes, it can lack resources and be obliged to use two steps or to sequence the
transition. This status can be read through the TAKEINFO command.
Before launching a TAKE command, the TAKEAVA status shall always be read to wait for the device to
be ready.
3.4.3 detailed commands sequence

Wait for the TAKE availability :

Launch the TAKE action : Launch the TAKE by writing the value 1.
Syntax : ,1GCtak
L
F
is the RCS² screen number minus 1.
Only value 1 is allowed, machine will immediately acknowledge the command, then will do the
transition and last will answer with the 0 value after the end of the TAKE.
3.4.4 example of TAKE
Picture 12 : example of TAKE