Analog Way MIDRA PLATFORM TPP Current Programmer's Guide - Manual (Page 15)

15
PROGRAMMER'S GUIDE FOR v01.02.11
o Read back using DIESE command :
At first, the controller should wait a possible current DIESE command to finish.
sending : # The controller asks for the current state of the DIESE command.
Answer : #
C
R
L
F
The controller must wait that the numerical equals
0, meaning that no enumeration is running.
sending : 1#
C
R
L
F
or 3#
C
R
L
F
When > is equal to 1, the device will enumerate all its registers values, for all
indexes in case of multidimensional registers.
When > is equal to 3, the device works the same way, except that it will not
enumerate registers having their default value, saving some amount of data.
o Registers read back managed by the controller :
The controller should read all used registers, slowly enough to avoid being saturated.