Dimplex DF2603 - Manual (Page 9)

5
WARNING
·
Ensure the power cord is not installed so that it is
pinched or against a sharp edge and ensure that the
power cord is stored or secured to avoid tripping or
snagging to reduce the risk of fire, electric shock or injury
to persons.
This section will explain the function of each convenient
control.
1. To access the controls, open the upper grill by pulling,
near the top, forward and down. (FIGURE 8)
2. To locate controls refer to FIGURE 9.
A. MAIN ON/OFF SWITCH
The ON/OFF SWITCH supplies power to all fireplace
functions (Heater /Flame).
RESETTING THE TEMPERATURE CUTOFF
SWITCH
This unit is equipped with a thermostat which controls the
temperature of the room. It does this by turning the
heater on and off. The heater is protected with a safety
device to prevent overheating. Should the heater
overheat, an automatic cut out will turn the heater off and
it will not come back on without being reset. It can be
reset by switching the ON/OFF SWITCH to OFF and
waiting 5 minutes before switching the unit back on.
CAUTION
·
If you need to continuously reset the heater, unplug the
unit and call your local dealer.
B. FLAME ACTION CONTROL (certain models only)
Turn the flame action control knob to adjust the flame
speed to the desired level.
C. FLAME BRIGHTNESS CONTROL
Turn the flame brightness control knob to increase or
decrease the brightness of the flame and embers.
OPERATION
FIGURE 7
SHIMS
FIGURE 8
GRILL
OPEN HERE
FIGURE 9
E D B C
A