Dimplex DF2603 - Manual (Page 8)

WARNING
·
Construction and Electrical Outlet wiring must comply with
local building codes and other applicable regulations to
reduce the risk of fire, electric shock and injury to persons.
Dimplex Mantel Surround Kit or custom made mantel
surround:
1. Select a suitable location that is not susceptible to
moisture and is away from drapes, furniture and high
traffic.
2. Place the Fireplace in the desired location to see how it
will look in the room.
3. For ease of electrical hook up you may wish to locate
the Fireplace near an existing outlet. (Refer to Note 1)
4. Store the Fireplace in a safe, dry and dust free location.
5. Assemble Mantel Surround Kit (Refer to instructions
provided with the Mantel Surround Kit) or construct the
custom surround with an opening of 26 1/2" wide X 23"
high (67.3cm wide X 58.4cm high) allowing a depth of
12" (30.5cm).
WARNING
·Do not attempt to wire your own new outlets or circuits. To
reduce the risk of fire, electric shock or injury to persons,
always use a licensed electrician.
This section provides easy step by step instructions for
installation of your Fireplace:
1. Install Trim Kit to front of Fireplace by positioning trim
then pushing straight forward against the Fireplace.
2. Make sure the unit is switched OFF (Refer to operating
instruction section).
3. Plug the Fireplace into a 15AMP/120Volt outlet. If the
cord does not reach you may use an extension cord
rated for a minimum of 1875 WATTS.
4. Push the Fireplace into place so that the trim is against
the finished Mantel Surround or wall surface.
(FIGURE 6).
5. Level, if required with wood shims (not included)
(FIGURE7).
4
FIREPLACE INSERT INSTALLATION
PUSH
FIGURE 6
TRIM
WALL OR
MANTEL
INSERT