Dimplex DF2603 - Manual (Page 12)

8
· To replace the top light bulbs which illuminate
the log exterior:
Bulb Requirements: Quantity of 2 clear chandelier or
candleabra bulbs with an E-12 (small) screw base.
Please refer to the label adjacent to the upper lights for
the correct wattage for your model.
CAUTION
·
Do not exceed 15 watts per bulb
1. Examine the bulbs to determine if they need
replacing. (FIGURE 14)
2. Hold the socket while unscrewing the bulb.
(FIGURE 13)
3. Hold the socket while screwing in the new bulb.
·
To reassemble light bulb area
1. Replace the glass and hold it in place at top.
(FIGURE 12)
2. Fasten retaining clip to hold glass in place.
(FIGURE 10)
Glass Cleaning:
The glass is cleaned in the factory during the assembly
operation. During shipment, installation, handling, etc.,
the glass surface may collect dust particles; these can be
removed by buffing lightly with a clean dry cloth.
To remove finger prints or other marks, the glass can be
cleaned with a damp cloth using a good quality
household glass cleaner. The glass should be completely
dried with a lint free cloth or paper towel.
CAUTION
·
Do not use abrasive cleaners on glass surface or spray
liquids directly onto any surface.
Helpful Hints
Wait until it is time to change the light bulbs to clean
inside glass surface.
FIGURE 14