Adamson S-Series - Manual (Page 25)

Page 25
3.7 Ground Stacking
Rigging
S-Series | Rigging
PINCH POINT
CAN CAUSE SEVERE
PERSONAL INJURY
WARNING
SAFETY RISK
PAY SPECIAL ATTENTION
The need for a removable pin when ground stacking no longer exists. A rotatable push pin now ensures that
ground stacked systems maintain their rigidity. This section assumes that the S10 is being stacked on an S119.
Stacking on the dolly is possible, please refer to section 4.0 for instructions regarding Dolly Stacking Legs.
Fig. 1
Fig. 2
2. Place the angle pin in the corresponding hole. (Fig. 2)
3. Remove the bottom link pin from the S10 to be ground stacked.
(Fig. 3)
Fig. 3
4. Place the bottom link pin back in the S10 to maintain the rigging
piece’s rigidity. (Fig. 4)
Fig. 4
1. Remove the angle pin and move the rigging knob to the position
specified in the mechanical tab of Blueprint AV™ (Fig. 1)