Adamson S-Series - Manual (Page 17)

Page 17
3.1 Rigging Overview
Rigging
S-Series | Rigging
ATTENTION
IMPORTANT OPERATING
INSTRUCTIONS
The S-Series Support Frame is designed for use with all S-Series enclosures. It consists of a
steel frame and can be paired with the S-Series Extender Beam. Always refer to Blueprint AV™
for correct rigging instructions.
In standalone mode, the frame can be used to lift flat to slightly-
angled arrays. Two rigging plates are provided for dual motor
operation, and if two motors are not available, one lifting plate
may be repositioned towards the center of the frame. Please
refer to Blueprint AV™ when determining proper lifting plate
location.
In order to attach the S-Series Extender Beam, the lifting plates
must be removed and replaced with Extended Beam plates.