Adamson S-Series - Manual (Page 16)

Page 16
3.1 Rigging Overview
The SlideLock Rigging System
Rigging
S-Series | Rigging
ATTENTION
IMPORTANT OPERATING
INSTRUCTIONS
The SlideLock Rigging System allows for the operator to set enclosure angles while still stacked on the dolly. A
series of push pins maintain angular position and lock in connecting rigging pieces. Caution should be taken while
connecting cabinets to ensure hands are out of the way.
The order of operation of the rigging system is: prep angles, remove connection pins, guide into place and secure
connecting pins.
Fig. 1
Fig. 2
0 0°
1 1°
2 2°
3 3°
4 4°
5 5°
6 6°
7 6.9°
8 10°
Storage in enclosure
There are 9 angles, 0 to 8, and an
additional ‘Storage’ being the ‘idle’
or ‘rest’ position, when the rigging
hardware is all the way down and
the boxes aren’t connected. It is
applicable when the enclosure is
not in use, to protect the rigging
hardware from damage. To keep the
system intact for transport, leave the
angles pinned in.
The angles are numbered as well
as color coded to mark which slot
should be pinned with the attached
push-pin. (Fig. 2) The following
rigging positions are equal to the
following degrees for the S10 (Fig. 1)