Adamson S-Series - Manual (Page 19)

Page 19
3.2 Rigging Sticker Legend
Rear Autolock Rigging Sticker Legend
* When releasing and pulling the system apart (to enclose rigging bars)
let knob slide down to ‘storage’ position ( magenta ), and place attached
push pin to magenta slot (above) If you’re dividing into 4 stacks, perform
this task on every 4th box only.
* When needing a zero degrees angle (such as the top boxes of longer
arrays) use Position 0, the magenta slot. Position 3 also uses the
magenta slot. Position 1 uses the purple slot, positions 2 and 5 use the
yellow slot, positions 4 and 7 use the green slot, position 6 uses the blue
slot and position 8 uses the beige slot.
* The S-Series Stacking Pin is to be used when needing to maintain
rigid angles either with a ground-stacked array, or an array with a high
amount of positive tilt. To engage the Stacking Pin, bring the enclosure
to its intended rigging position limit, press the Stacking Pin in and turn
clockwise. To release the stacking pin, turn it counter-clockwise.
Rigging
S-Series | Rigging
ATTENTION
IMPORTANT OPERATING
INSTRUCTIONS