Adamson S-Series - Manual (Page 20)

Page 20
Setting the angles on all 4-stacks and basic preparation.
Before attaching cabinets together, use Blueprint AV™ to plan your cabinet angles for desired coverage. Prepare all
the cabinet angles before beginning to attach and lift the array. The top cabinet, which attaches to the rigging frame
is number 1, and the cabinets gain numerically as the descend. Make sure you are setting the correct angle on both
sides of the SlideLock rigging system.
Fig. 1
Fig. 2
3.3 Setting Angles
Rigging
S-Series | Rigging
ATTENTION
IMPORTANT OPERATING
INSTRUCTIONS
1. Remove the angle pin. (Fig. 1)
2. Raise the sliding knob to the angle specified by corresponding
Blueprint AV design. (Fig. 2)
3. Place the angle pin in the coloured slot that corresponds to the
sliding knob position. (Fig. 3)
Fig. 3
4. Repeat for all enclosures. (Fig. 4)
Fig. 4