Xtramus NuDC-4U V2.1 - Manual (Page 36)

36
6.2. Upgrading NuDC-4U’s Firmware/FPGA
Before upgrading NuDC-4U’s firmware/FPGA, please be sure that your NuDC-4U is connected to PC via
a USB cable as shown in the figure down below:
The following instructions are for upgrading NuDC-4U’s firmware. The process for upgrading NuDC-4U’s
FPGA is identical to upgrading NuDC-4U’s firmware, and can be related.
Upgrading NuDC-4U’s Firmware/FPGA
Click Service on the Menu Bar, and then choose
System Upgrade
Æ Firmware Upgrade/FPGA
Upgrade
.
A Load File window will pop up. Choose the
firmware/FPGA file you would like to upgrade, and
click Open.
Please note that both NuDC-4U’s firmware and FPGA
are in “＊.bin” format.
Click YES to continue, or click NO to cancel
firmware/FPGA upgrading process.
NuDC-4U utility software will start uploading the
firmware/FPGA you chose to NuDC-4U.
Please note that NuDC-4U’s power must be
ALWAYS ON during this process
.
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®