Xtramus NuApps-2889-RM V1.1 - Manual (Page 33)

Test Setup
Duration (Sec) The time duration of each test.
Number of Trials The number of the test trial.
Wait for Read
Counter (Sec)
The time gap for showing the counter result.
Learning Setup
¾ Learning Mode: Scroll down to
choose Learning Mode as Never,
Once or Every Trial.
¾ Delay Time After Learning: Set
the time gap between Learning
and the next step.
¾ Frame Count: The number of
frame to be sent.
¾ Frame Gap: The gap in bits
between frames.
Click OK to save the settings, click
Cancel to exit this setting window
without saving, or click Default to
recover the setting to the default
value.
Frame Error Type
CRC Error Enable the CRC Error test of your DUT.
Under Size Enable the Under Size test of your DUT.
Alignment Error Enable the Alignment Error test of your DUT.
Dribble Bits Enable the Dribble Bits test of your DUT.
Over Size Enable the Over Size test of your DUT.
Frame size with CRC (Bytes)
Size Set the frame size with CRC on this field.
Over size Set the maximum frame size with CRC on this field.
Under Size Set the minimum frame size with CRC on this field.
Bi-Direction Enable Bi-Direction between Port A and Port B as Source/Destination port.
Load
Starting from(%) The initial loading percentage.
Stopping at(%) The end loading percentage.
Percentage
Step(%)
The percentage of loading to be added at each step.
33
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®