Xtramus NuApps-2889-RM V1.1 User Manual

Page 13

Website: www.Xtramus.com

XTRAMUS TECHNOLOGIES

Please follow the steps down below to starts NuApps-2889-RM and NuServer properly.

Starting NuServer / NuApps-2889-RM

When starting NuApps-2889-RM, a “Connect to NuServer”
window will pop up and asked how you are going to connect to
NuServer.

Local Host: Choose this option when you’re running

NuApps-2889-RM from NuStreams-2000i IPC module or a PC
that’s connected to NuStreams-2000i/600i via an RJ45 cable.

Remote: Choose this option when you’re running

NuApps-2889-RM from other PC located on the network.
Choose the IP address which is assigned from
NuStreams-2000i/600i from the scroll-down menu, or choose
demo to enter NuApps-2889-RM’s Demo Mode.

Connect/Cancel: Click the Connect/Cancel button to connect

to NuStreams-2000i/600i or cancel starting NuApps-2889-RM.

A “NuServer-NIC Information” window will pop up. Please select the NIC (Network Interface Card) which
is connected to NuStreams -2000i/ 600i’s from the Network Interface Information table, and click OK. If
you’re using NuStreams-2000i’s IPC module, please choose “Realtek RTL8139 Family Fast Ethernet”.

NuServer will connect to the daughter boards, and NuApps-2889-RM will start as well.