Xtramus DApps-TAP V1.3 - Manual (Page 22)

5. Installing/Uninstalling DApps-TAP
Please follow the steps down below to install DApps-TAP. Also, please note that DO NOT connect your
NuDOG-301C, NuDOG-801 or NuDOG-101T to your PC before DApps-TAP is properly installed on your
PC.
Installing DApps-TAP
1. Double-click DApps-TAP installation program
and start the installation process*.
2. InstallShield Wizard is starting to install
DApps-TAP. If you would like to cancel
installation, click “Cancel”.
3. Click “Next” to continue installation.
*Note: Due to different Operating Systems or system settings, warning messages might pop up when installing
DApps-TAP or driver for your device. When this occurs, please choose the options on these pop-up warning messages
that allow you to continue installing DApps-TAP or device driver.
22
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®