Vectronics VEC-221K User Manual
Page 29
VEC-221K Instruction Manual
CW Memory Keyer Kit
24
/G#
Gap
−
inserts a gap of # standard intra-character spaces into the
message, where # is a digit in the range of 1 to 9 (0 can be used
but not practical). Invalid numeral code will automatically
default to zero. This command is used to exaggerate inter-
character and word spacing.
/L
Loop
−
creates a message loop (message repeat). Note that any
character recorded after
"/L"
will not be sent.
Example:
BEACON AA5CS 5 W /L
/N
Number
−
inserts a contest serial number, in the range of 001 to
9999, into the message. Only three digits are sent for numbers
less than 1000--use leading zeros when appropriate. The serial
number is automatically post-incremented each time it is sent
(9999 will increment to 0001, skipping 0000 since it is not used)
and is updated in the non-volatile memory when the message is
finished. The serial number is set to the same one as before
when power on. If a different serial number is desired, it must
be set using the paddle-entered Number function.
Example:
YOU ARE CONTACT NR /N
/Pmmss
Pause
−
inserts a timed pause of mm minutes and ss seconds into
the message. Four numbers must follow "/P". Invalid numeral
code will automatically default to zero.
Example:
TIMEOUT 1 HOUR /P6000 TIMEOUT 1.5 MIN /P0090
TIMEOUT 1 HR 40 MIN 39 SEC /P9999
/S
Space
−
inserts an extra standard word space into the message.
This command yields the same result as "/G7" but uses one less
unit of memory.
//
Slash character
−
stores the slash character "/" into the message.
/#
Message call
−
inserts message number # into the current
message, where # is a digit from 1 to 4.
Morse Code Character Set
1
A di-dah
•−
N
dah-dit
−•
B dah-di-di-dit
−•••
O
dah-dah-dah
−−−
C dah-di-dah-dit
−•−•
P
di-dah-dah-dit
•−−•
D dah-di-dit
−••
Q
dah-dah-di-dah
−−•−
E dit
•
R
di-dah-dit
•−•
F di-di-dah-dit
••−•
S
di-di-dit
•••
G dah-dah-dit
−−•
T
dah
−