Vectronics VEC-101K - Manual (Page 4)

VEC-101K Owner's Manual Shortwave Converter Kit
2
!
Bright Desk Lamp
!
Magnifying Glass
Special Tools for This Kit:
!
“Blade” type tuning tool or jeweler’s screwdriver.
BEFORE YOU START BUILDING
Experience shows there are four common mistakes builders commonly make.
Avoid these, and your kit will probably work on the first try!
1. Installing the Wrong Part: It always pays to double-check each step. A 1K
and a 10K resistor may look almost the same, but may act very differently in
an electronic circuit! The same is true for capacitors—a device marked 102
(or .001 uF) may have very different operating characteristics from one
marked 103 (or .01 uF).
2. Installing Parts Backwards: Always check the polarity of electrolytic
capacitors to make sure the positive (+) lead goes in the (+) hole on the
circuit board. Transistors have a flat side or emitter tab to help you identify
the correct mounting position. ICs have a notch or dot at one end indicating
the correct direction of insertion. Diodes have a banded end indicating
correct polarity.
3. Faulty Solder Connections: Inspect for cold-solder joints and solder
bridges. Cold solder joints occur when you don’t fully heat the connection
or when metallic corrosion and oxide contaminate a component lead or pad.
Solder bridges form when a trail of excess solder shorts pads or tracks
together (see Solder Tips below).
4. Omitting or Misreading a Part: This is easier to do than you might think!
Always double-check to make sure you completed each step in an assembly
sequence.
Soldering Tips: Cleanliness and good heat distribution are the two secrets of
professional soldering. Before you install and solder each part, inspect leads or
pins for oxidation. If the metal surface is dull, sand with fine emery paper until
shiny. Allow the tip of your iron to contact both the lead and pad for about one
second (count “one-thousand-one”) before feeding solder to the connection.
Surfaces must become hot enough for solder to flow smoothly. Feed solder to
the opposite side of the lead from your iron tip. Solder will wick around the lead
toward the tip, wetting all exposed surfaces.