Vectronics VEC-101K - Manual (Page 14)

VEC-101K Owner's Manual Shortwave Converter Kit
12
The IC body has a small notch, or key, molded at one end, indicating pins 1 and
8. A small dimple-like body-molding is often found adjacent to pin 1. Some IC
packages may include both key indicators.
span
discarded lea
Locate the 8-pin NE602 (may be marked as NE602, SA602, or NE612).
! ! 3. Align the body of the NE602 to correspond with the key of socket U1.
Loosely insert the NE602 pins into socket U1. All 8 pins should fit
freely into the socket openings. If not, straighten the IC pins until they
do. Using firm and steady pressure, fully seat the IC into the socket.
! ! 4. Locate the push-action DPDT band switch. Install and solder at SW2.
The push shaft should extend over the front of the board. Be sure the
switch is fully seated and level before soldering.
! ! 5. Locate the push-action 4PDT power/bypass switch. Install and solder
at location SW1. The push shaft should extend over the front of the
board. Be sure the switch is fully seated and level before soldering.
Push-rod
SW2
SW1
Phase 4: Phone Jacks/Battery Clip/Tie Wrap