Controls & functions, Front – TVLogic LVM-247W User Manual
Page 8

8 Multi Format LCD Monitor
3. Controls & Functions
FRONT
●
[STATUS INDICATOR] Lamp
- Used to display the current input mode.
- Input Mode
VIDEO : COMPOSITE 1/2/3
S-VID : S-VIDEO
COMP : COMPONENT
RGB : RGB
DVI-A : DVI ANALOG
DVI-D : DVI DIGITAL
HDMI : HDMI
SDI-A : SDI-A
SDI-B : SDI-B
- In PBP mode, each screen’s input modes are
displayed.
Ex) When SDI-A input and COMPOSITE 1 input
are selected for left screen and right screen
respectively, SDI-A lamp and VIDEO lamp will
light.
●
[ANALOG] Button/Lamp
- Used to select the desired Analog input.
Press the button to activate the analog input
menu-selection, then use UP and DOWN
button to select desired input.
* See section “Other Functions [1]ANALOG
Button” for more information.
●
[SDI-A] Button/lamp
- Used when SDI-A INPUT is selected.
●
[SDI-B] Button/lamp
- Used when SDI-B INPUT is selected.
●
[ANALOG] button/lamp
- Used to select desired Analog Input. Press
the button to activate the analog input menu
selection, then use UP and DOWN button to
select desired input.
●
[PBP] button/lamp
- Used to select PBP(Picture-by-Picture) function.
- Selects order of operation: mode 1 ->
mode 2 -> mode 3 in sequence.
* MODE 1 : Two images are display in the
center of the monitor with maintain their
screen ratio.
* MODE 2 : Two images are display with fill full
in the monitor.
* MODE 3 : Left input signal displays in the left
side of the monitor, right input signal displays
in the right side monitor with maintain their
screen raitio.
●
[F1][F2][F3][F4] button/lamp
- This Functions button is used to activate the
feature selected in “System- KEY FUNCTION
1/2/3/4 ” menu.
- [F1] button is used to select a screen in PBP
mode.
* See the “MENU Contents -> [9] SYSTEM Page”
for more information.
●
[SCAN] button/lamp
- Used to change the Scan mode. The mode is
changed as the following sequence.
OVER SCAN -> ZERO SCAN -> UNDER SCAN
-> 2:1 SCAN -> 1:1 SCAN -> FIT WIDTH ->
ZOOM(PBP 16:9 Mode)
* See the “Other Functions -> [2] SCAN Page”
for more information.
●
[MARKER] button/lamp
- Used to activate or inactivate the marker.
The desired aspect ratio can be displayed on
the screen properly when the type of marker
selected from the main menu.
MODE1
MODE2
MODE 3