beautypg.com

Fueling, Check before lighting – Toyotomi Omni 230 User Manual

Page 8

background image

FUELING

1. lnsert the straight tube of the manual fuel siphon into the kerosene (paraffin)

container. Remove the fuel tank cap on the heater, and insert the siphon’s flexible

hose into the fuel tank opening.

2. Turn the air vent knob on the top of the siphon clockwise to close the air vent.

3. To start the flow of kerosene (paraffin), squeeze the bulb of the siphon vigorously

six or seven times. Once the flow begins, it is no longer necessary to squeeze the

bulb. To avoid overfilling the tank, watch the fuel gauge. As the indicator enters the

red zone, stop the flow by turning the air vent knob counterclockwise.

NOTE: Be especially careful to avoid overfilling the tank with very cold kerosene

(paraffin); otherwise overflow might occur when the fuel warms up.

4. Remove the siphon carefully, allowing the excess kerosene (paraffin) to drain from

the tube back into container. Replace the fuel tank cap and tighten it securely. Be

sure to wipe away any spilled kerosene (paraffin) from tank or other heater parts.

CHECK BEFORE LIGHTING

1. LOCATE YOUR HEATER AWAY FROM WALLS AND AVOID DRAFTS

Allow at least one (1) m of clearance between the heater and walls, curtains, shelving or other combustible

materials. DO NOT operate your heater in drafty areas or locations where opening doors may create gusts of air.

Drafts or strong air currents may make flame unstable and affect heater performance.

2. LEVEL THE HEATER

The heater should be operated on a firm, Ievel floor.

NOTE: lf your heater is not level, change Iocations. DO NOT attempt to prop it up

with books or other objects. An unlevel heater may burn with an uneven flame.

3. CHECK THE WICK LIFE EXTENDER

When you first use your new heater or after replacing the wick, check if the WICK

LIFE EXTENDER is on position 1. If not, readjust the wick life extender mechanism

to position 1 by following the instructions on page 9, ADJUSTMENT OF WICK

HEIGHT WITH WICK LIFE EXTENDER.

4. ENGAGE THE AUTOMATIC EXTINGUISHER

The automatic extinguisher is engaged automatically by turning the wick adjuster

knob clockwise. Check the operation of the automatic extinguisher before lighting

your heater. After turning the wick adjuster knob clockwise until it stops, turn the

manual shutoff counterclockwise to be sure the wick moves smoothly down.

7

F

E

USE KEROSENE ONLY

(PARAFFIN)

Use only clean Kerosene (paraffin).
NEVER use gasoline (petrol) or other flammable liquids.
ALWAYS extinguish heater before refill heater fuel tank.
Fuel heater outside the living area.

WARNING:

Omni 230 Type C_US.qxd 14.8.1 13:15 ページ 7