Storage, Replacing the mica window – Toyotomi Omni 230 User Manual
Page 16

15
REPLACING THE MICA WINDOW
1. Remove screw from the mica window frame and lift mica window off.
2. Align notch in mica window with hole on mica window frame.
Insert tab of the mica window frame into outer cover slot. Replace screw.
STORAGE
At the end of each heating season, or when you do not plan to use your heater for an extended period of time, the
following procedures are recommended.
1. CLEAN WlCK AND HEATER
Follow directions in item 2 under “INSPECTlON OF THE WlCK”.
2. DRAIN FUEL TANK
After you have burned your heater dry, a small amount of kerosene (paraffin) will remain in the fuel tank. lt should
be removed in order to avoid contamination when the heater is refueled at a later date. To do this, remove the
fuel cap, tip the heater toward you and insert a small syringe into the bottom-most portion of the fuel tank.
Empty the tank completely before storage.
3. REMOVE BATTERIES FROM BATTERY HOLDER
4. STORE HEATER
The original shipping carton is the best place to store your heater. If you do not have original packing
materials, cover the heater with a large plastic bag and store in a dry place.
WARNING: Before replacing the mica window, allow heater to cool completely.
Omni 230 Type C_US.qxd 14.8.1 13:15 ページ 15