Toyotomi Omni 230 - Manual (Page 11)

When the wick adjuster knob is removed, the wick life extender control can be seen
to contain 3 sequential holes marked 1 , 2 and 3. By pulling out and turning the
control dial counterclockwise, the stem pin of the adjuster can be moved from 1
to 2 and to 3 position as required. Each step upward from a lower to a higher
number increases the maximum wick adjustment range by 2 mm (approx. 1/13 in.).
After the wick life extender’s dial has been set, be sure the MANUAL SHUTOFF
knob is in the “OFF” position. Replace the wick adjuster knob, making sure it is
engaged securely on the wick adjuster shaft.
Repeat steps 1 through 3, as needed, in the section titled “ADJUSTING THE
FLAME”. When suitable flame length can no longer be achieved even on pin
position 3 , the wick should be replaced.
NOTE : DO NOT move adjuster to higher position until lower position no longer
gives adequate flame length, even after “burning dry”.
Before replacing wick, be sure to move the wick life extender dial back to its 1
position.
CHECK THE OPERATION OF THE AUTOMATIC EXTINGUISHER BEFORE
LIGHTING YOUR HEATER.
EXTINGUISHING THE FLAME
1. Turn the wick adjuster knob counterclockwise until it stops (about 3/4 turn). Within
a few moments, the flame will be completely extinguished and the heater will be off.
2. Make sure the flame is out completely.
3. DO NOT try to relight the heater for at least three (3) minutes after turning it off, as
this may cause smoke and odor.
MANUAL SHUTOFF
When quick shutoff is necessary, push the manual shutoff.
NOTE: For routine turn-off, DO NOT use the “Manual Shutoff” or activate the
“Automatic Extinguisher” by jarring the heater. These methods may cause
unwanted odor, soot and smoke. Only the wick adjuster knob should be used
for normal shutoff.
10
Wick heigh adjuster knob
(Wick life extender control)
Stem pin
Omni 230 Type C_US.qxd 14.8.1 13:15 ページ 10