Toyotomi Omni 230 - Manual (Page 7)

ASSEMBLY AND OPERATlON
lNSPECTlON AND ASSEMBLY
NOTE: Save the shipping carton and packing materials for future storage of your heater.
1. REMOVE PACKING MATERIALS
Remove all packing materials from your heater and install the guard as follows:
a) After removing the top plate, take the packing materials out of the outer cover.
b) Put the top plate back on the top of the outer cover.
2. INSTALL DRIP TRAY
NOTE: DO NOT operate your heater without the drip tray.
Place the drip tray on the floor.
● Place the heater on the drip tray so the three (3) legs of the heater are next to the three
(3) tabs on the tray.
● Turn the heater clockwise until the feet slide into their tabs.
3. INSTALL BATTERIES
Locate the battery holder on the back of your heater. Remove the battery holder cover.
● Insert the four (4) “C” size batteries according to the plus (+) and minus (–) markings
inside the holder.
4. CHECK SCREWS
Make sure that three (3) screws around the outer cover assembly above the fuel tank are
tight.
6
Top plate
Outer
cover
Packing
material
Tray
Fuel tank
Tab
CAUTION: Risk of fire. The packing materials are flammable.
Omni 230 Type C_US.qxd 14.8.1 13:15 ページ 6