Toyotomi Omni 230 - Manual (Page 13)

CLEANING THE HEATER
1. Cleaning the outer cover and the fuel tank.
Wipe the surface of the outer cover and the fuel tank with a soft cloth.
Stains can be removed with a cloth and a mind soapy solution.
DO NOT use scouring pads, or harsh abrasibes.
2. Chrome guard
A non-abrasive metal polisher can be used with a soft cloth to polish the guard.
3. Heat chamber
Loose cinders or soot on the heat chamber can be brushed away.
CHECKING THE AUTOMATIC EXTINGUISHER
Test the operation of the automatic extinguisher weekly. A good time to check is before lighting the heater.
1. Turn the wick adjuster knob clocwise until it stops (the same way as to light the heater).
2. Push the manual shutoff and make sure the wick has dropped.
3. Repeat step 1 and then shake the heater and make sure the automatic extinguisher worked.
REPLACEMENT OF PARTS
REPLACING THE WlCK
USE ONLY GENUINE TOYOTOMI REPLACEMENT WlCK. SUBSTITUTE WICKS CAN SEVERELY REDUCE
PERFORMANCE AND SAFETY.
1. Release the automatic extinguisher by pushing down on the manual shutoff.
2. Remove the three (3) screws holding the outer cover by using the screwdriver, and
lift cover off. Remove batteries from the battery holder.
12
WARNING: Before disassembling your heater, allow it to cool completely.
Omni 230 Type C_US.qxd 14.8.1 13:15 ページ 12