Setting up of the working mode – Televes COAXDATA GATEWAY 1Gbps User Manual

Page 15

Data Over Coax Gateway

Ref.769301

Setting up of the working mode

The working mode hast to be set through the Web interface on the

Network Settings.

The produt has

two operation modes deppending on the type of network bein deployed.

AP Bridge Mode



AP Bridge

: This mode brings up a

local network where communication
between all interfaces is allowed. This
type of network is mostly indicated for

home use.

IMPORTANT NOTE: In this mode the
CoaxManager application can be
used to configure the coaxial/plc
interface.

Router Mode



Router

: This is the factory default

working mode. Under this mode the
device will route between the
coaxial/plc (WAN) interface and the
Ethernet / WiFi (LAN) interfaces.

Router mode supports three configuration protocols depending on the type of access to the internet.
DHCP (Authomatic), Static and PPPoE.



DHCP

: This mode sets the

configuration of the WAN interface
(coaxial/PLC) through a DHCP
server connected to the Master of
the network.