TabletKiosk Sahara Slate PC i400 Series - Manual (Page 104)

Chapter 07: Upgrading Your Sahara Slate PC
are inside. The wireless adapter is
located at the bottom of the slot
and is seated inside a small slot
connector.
4. The wireless card is held in
place by two small screws. First,
carefully remove the yellow tape
covering the screws and antenna
leads. Then remove the screws and set
them aside in a safe place. Once the
screws are removed, the card will
pop up slightly.
5. Carefully slide the card out of
the slot. Be sure to unclip the
antenna leads from the card
before fully removing the card
from the interior of the
compartment.
6. Take the new wireless networking
card you obtained from your
authorized dealer and attach
the antenna leads. Carefully
align the card and slide it into
the connector slot.
7. Press downward on the card to
push it into position and replace the
screws that secure the networking card in place.
8. Replace the tape over the screws and antenna leads and
replace the cover and tighten the screws that hold the cover
in place.