Presentation Switchers PS550 - Manual (Page 33)

Page 33 Series 500 Installation Guide
Testing the Complete System Testing the Complete System
Front Panel Power Cycle Front Panel Power Cycle
From the front panel, press and hold the Cancel bu on for three (3) seconds. The front panel
LEDs will blink once and the power will be cycled. If the system is in the power on mode then
the power off commands will be ini ated. If in power off mode the power on commands will be
issued.
No Signal Power Off No Signal Power Off
Select a signal that is not connected or remove the video connector on the ac ve selected input
source. Display device should go blank or “looking for a signal” mode. A er the predetermined
me of non-signal the system should shut down properly.
Enabling or Disabling the Display Control Feature Enabling or Disabling the Display Control Feature
The Series 500 Display Control feature is automa cally turned on when one has succesfully
uploaded codes using the PS 500 Display Control applica on.
However, the Display Control feature may be enabled or disabled using the front panel menu
system. See the Control Se ngs sec on en tled, “Display Control On/Off ” in this Installa on
Guide.