Presentation Switchers PS550 - Manual (Page 23)

Page 23 Series 500 Installation Guide
2. Rotate knob to Communica ons and press knob (or select Input 4 bu on).
3. Rotate knob to Serial RS-232 and press knob (or select Input 1 bu on).
4. Rotate the knob to select the preferred baud rate and press (the volume knob).
Display Network Port Settings Display Network Port Settings
This feature lists the current Network port se ngs, including Ethernet IP address and DHCP
se ngs. To change the se ngs you will need to Communica on se ngs sec on later in this
chapter.
To begin, ensure that the main default screen is displayed. The main screen displays the current
input and volume level. If this screen is not currently displayed, press the Cancel bu on repeat-
edly un l the main screen is illuminated.
To display the current network port se ngs follow these steps:
1. Press the volume control knob once to enter the menu mode.
2. Rotate knob to Status and press knob (or select Input 1 bu on)
3. Rotate knob to Communica ons and press knob (or select Input 3 bu on).
4. Rotate knob to Network and press knob (or select Input 2 bu on).
5. The LCD will now display the Network port se ngs. Scroll down to see addi onal informa-
on including address acquisi on method (DHCP vs. Sta c), Subnet Mask, Gateway address, and
MAC address.
MAIN MENU
1.>STATUS
COMMUNICATIONS
1.>SERIAL RS-232
SERIAL RS-232
1.>BAUD RATE
SELECT BAUD RATE
1.>115200
MAIN MENU
1.>STATUS
3.>COMMUNICATION
4. SYSTEM
STATUS
1.>OUTPUT
1. SERIAL
2.>NETWORK
Press: 1 3 2
Shortcut