Oklahoma Sound #MMC - Manual (Page 7)

7
Step 7:
a) ConƟnue by carefully liŌing the cabinet
over the base panel and align the cam
bolts with the cam locks and gently lower
the cabinet to join the cabinet with the
base panel. The six wooden dowels on the
edge of the three cabinet panels will also
slip in to the six pre drilled holes on the
base panel #4 as shown.
b) Use the screwdriver to turn all the cam
locks to lock the cabinet to the base panel.
Be sure that all your cams are Ɵghten well.
c) Use the cam lock covers D to cover all your
cam locks.
Step 8:
a) Lay the two panel #6 on a clean soŌ
surface with the pre-drilled holes facing
upwards.
b) IdenƟfy the four flip-up bracket #K and
sixteen screws #I.
c) Be sure to place the brackets to the
panel with the mounƟng porƟon of the
bracket at the edge of the panel as
shown.
d) Proceed by screwing two brackets to
the boƩom of each panel by using a
Phillips screwdriver. Four screws #I per
bracket as shown.