Oklahoma Sound #MMC - Manual (Page 14)

14
Step 21:
a) IdenƟfy the door panel #8 and lay it down on a
soŌ, clean surface with the predrilled holes facing
up as shown. Begin by taking the two male parts
of the hinges part #N and insert them in the two
routed out holes on the edge of the panel as
shown.
b) Use two screw #V to screw them into place using a
Phillips screwdriver to screw them into the
predrilled holes on the panel next to the holes.
c) Proceed to idenƟfy the lock assembly #P. Insert
the barrel of the lock through the predrilled hole
with the lock facing the edge of the panel as
shown. AƩach the lock assembly using four screws
#V into the predrilled holes as shown.
d) Place the ring around the barrel of the lock from
the outside of the panel with the spikes slipping
between the barrel and the panel as shown.
e) AƩach the silver handle part #L by placing it over
the two holes on the front of the panel.
f) Use two screw #F to aƩach the handle to the pan-
el. Use a Phillips screwdriver to aƩach the handle
Ɵghtly to the panel.
Step 22:
Door InstallaƟon:
a) Proceed to take the door and insert the two male
ends of the hinge that is aƩached to the door and
lay it over the two female ends of the hinge that
are located on the inside of the cabinet as shown.
b) The notch at the end of the hinge Parts #N will slip
around the pre-aƩached screw at the end of part
#O. You may need to loosen the screw to allow
the hinge to slip around.
c) Once the hinge is inserted all the way turn the
aƩached screw to firmly aƩach the two parts of
the hinge together aƩaching the door in place.