NEXCOM VMC 100 User Manual

Page 21

VMC 100/1100 Series User Manual

Chapter 1: Product Introduction

I/O Interface-Rear
• 1x 5pin circular connector for Power/Ignition input
• 1x RJ45 for LAN
• 1x RJ45 for Full RS-232 with 0V/5V/12V power supply (0.5A)
• 1x DB9 (Male) for

RX/TX or RS-485

1x CAN Bus 2.0

• 1x DB15 (Female) for

GPS dead reckoning interface (optional)

2x PWM, 2x Analog Input, 3x GPO, 3x GPI

Analog Input requirement for Voltages are measured

Channel: 8

Voltage range: 0~38V

Resolution: 8 bit

Analog Input requirement for Frequency, Speed

Square wave

Frequency signal offset voltage range: 0~15VDC

Protection: +/- 500V spike

Frequency signal duty cycle range: 10%~90%

Communication Module
• 1x Onboard GPS module
• 1x WLAN or Bluetooth module for optional
• 1x WWAN module for optional

Power Management
• Selectable boot-up & shut-down voltage for low power protection
• HW design ready for 8-level delay time on/off at user’s self configuration
• Power on/off ignition, software detectable
• Support S3 and S4 suspend mode; wake on RTC and SMS

Operating System
• Windows 8 Professional, WES8

• Windows 7, WES7

• Linux Fedora (kernel V3.2.0)

Operating System
• Operating temperatures: Ambient with air -20°C to 60°C

• Storage temperatures: -30°C to 80°C

• Relative humidity: 10% to 90% (non-condensing)

• Vibration (random): 3g @5~500Hz

• Vibration

Operating: MIL-STD-810G, 514.6 Procedure 1, Category 4

Storage: MIL-STD-810G, 514.6 Procedure 1, Category 24

• Shock

Operating: MIL-STD-810G, Method 516.6, Procedure I, trucks and semi-

trailers= 20g

Crash hazard: MIL-STD-810G, Method 516.6, Procedure V, ground

equipment= 75g

Power Design & Protection
• Load dump and inductive load protection

• Cold cranking protection

• Transient voltage protection

• Electrostatic discharge protection

Standards/Certifications
• EMC

CE, FCC class B

• Power

SAE J1113

SAE J1455

ISO 7637-2

• Safety

EN 60950-1 LVD

This manual is related to the following products:

VMC 1100