NEXCOM VMC 100 User Manual

Page 19

VMC 100/1100 Series User Manual

Chapter 1: Product Introduction

I/O Interface-Rear
• 1x 5pin circular connector for Power/Ignition input
• 1x RJ45 for LAN
• 1x RJ45 for full RS-232 with 0V/5V/12V power supply (0.5A)
• 1x DB9 (Male) for
RX/TX or RS-485
2x CAN Bus 2.0
• 1x DB15 (Female) for
GPS dead reckoning interface (optional)
3x GPO, 3x GPI

Communication Module
• 1x Onboard GPS module
• 1x WLAN or Bluetooth module for optional
• 1x WWAN module for optional

Power Management
• Selectable boot-up & shut-down voltage for low power protection
• HW design ready for 8-level delay time on/off at user’s self configuration
• Power on/off ignition, software detectable

Operating System
• Linux Ubuntu (kernel V3.2.0)

Operating System
• Operating temperatures: Ambient with air -20°C to 70°C
• Storage temperatures: -30°C to 80°C
• Relative humidity: 10% to 90% (non-condensing)

• Vibration (random) : 3g @5~500Hz
• Vibration:
Operating: MIL-STD-810G, 514.6 Procedure 1, Category 4
Storage: MIL-STD-810G, 514.6 Procedure 1, Category 24
• Shock:
Operating: MIL-STD-810G, Method 516.6, Procedure I, trucks and

semi-trailers= 20g

Crash hazard: MIL-STD-810G, Method 516.6, Procedure V, ground

equipment= 75g

Power Design & Protection
• Load dump and inductive load protection
• Cold cranking protection
• Transient voltage protection
• Electrostatic discharge protection

Standards/Certifications
• EMC

CE, FCC class B

• Power

SAE J1113

SAE J1455

ISO 7637-2

• Safety

EN 60950-1 LVD

This manual is related to the following products:

VMC 1100