NEXCOM VMC 100 - Manual (Page 110)

Copyright © 2014 NEXCOM International Co., Ltd. All rights reserved 96 VMC 100/1100 Series User Manual
Appendix E: Auto Backlight Setting
a
PPendIx
e: a
uto
b
aCKlIght
s
ettIng
(1) Press on “Advanced” of the main menu screen.
(2) Select “Intel IGD Configuration.”
(3) Change the value to “Enable” for “Auto-BackLight Select.”
Advanced Boot Security Save & Exit Main
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 America Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Config Intel IGD Settings.
ACPI Settings
CPU Configuration
Power Management Configuration
Module Management
Intel IGD Configuration
SATA Configuration
USB Configuration
W83792D H/W Monitor
Super IO Configuration
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable or Disable
Auto-BackLight function.
Intel IGD Configuration
Auto-BackLight Select [Disabled]
Auto-BackLight Select
Enable
Disable
(4) After you have finished with the Setup, press to go back to the
main menu and then press “Enter” on “Save Changes and Reset.”
After the setup procedure is completed, the light sensors can auto-adjust a
display’s backlight.