Hardware specifications – NEXCOM VTC 2100 User Manual

Page 15

VTC 2100 User Manual

Chapter 1: Product Introduction

Hardware Specifications

Main Chipset
• Intel

ICH8M

CPU
• Intel

Atom™ D410 Single Core 1.6GHz

Memory
• DDR2 667/800 SDRAM
• One 200-pin SO-DIMM up to 2GB

Expansion
• Mini PCIe socket (PCIe + USB) x 1 (for WLAN module)
• Mini PCIe socket (USB) x 1 (for 3.5G module)
• 1 x Bluetooth module (optional)
• 1 x GPS module
• PCI-104 x 1

I/O Interfaces - Front
• 5 x LEDs for power stand-by (on power button), Power Status, HDD,

WLAN/HSDPA and GPIO

• Power button
• 2 x USB ports
• 1 x SIM card socket
• 1 x system reset button
• 1 x Mic-In, 1 x Line-Out
• 4 x mounting holes SMA-type for WLAN/ HSDPA/BT

I/O Interfaces - Rear
• Mounting hole reserved:
For RF Coax to SMA Bulkhead x 1 (for GPS) reference, signal connects to

the function board

• 8V~60V wide range DC power input, power ignition signal control
• Dual VGA output (clone mode)
• 5V/1A, 12V/1A DC power output, can be controlled by S/W
• 1 x Mic-In, 1 x Line-Out
• 2 x RS232 (COM1/2)
1 x RS485 (COM3)
• 2 x USB 2.0
• 1 x LVDS (DB26 female connector for LVDS with backlight, control

power [+12V] and USB 2.0 x 1)

• 10/100/1000 Fast Ethernet, RJ45 with LED connector x 1
• GPIO x 1 (4 input & 4 output)

Expandable Storage
• SATA 2.5” HDD Bay x 1
• SATA DOM x 1

Power Management
• Selectable boot-up & shut-down voltage for low power protection
• HW design ready for 8-level delay time on/off at user’s self configuration
• Power on/off ignition, software detectable
• Supports S3/S4 suspend mode