Appendix d: rtc wake-up setting – NEXCOM VTC 1000 User Manual
Page 66
Copyright © 2011 NEXCOM International Co., Ltd. All rights reserved
53
VTC 1000 User Manual
Appendix D: RTC Wake-up setting
Appendix D: RTC Wake-up setting
(1) Press
(2) Select “Module Management”
(3) Change the value to “Enable” for “Wake On RTC Module”
Save & Exit
Advanced
Chipset
Boot
Security
Main
Version 2.10.1208. Copyright (C) 2010 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2010 America Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Onboard Module Support
Legacy OpROM Support
Launch PXE OpROM
Launch Storage OpROM
CPU Configuration
Power Management Configuration
Module Management
Thermal Configuration
USB Configuration
Super IO Configuration
H/W Monitor
[Disabled]
[Enabled]
Advanced
Version 2.10.1208. Copyright (C) 2010 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2010 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
User Setting Hour.
Power Management Configuration
** External +5V & +12V Power Setting **
External Power
** Startup & Shutdown Voltage Setting **
Input Voltage
Startup,Shutdown
**Delay Time Setting**
Power On Delay
Power Off Delay
Onboard Module Supported
3.5G Module
Wake On 3.5G Module
WLAN Module
Status of RS422/485 MODULE1
Status of RS422/485 MODULE2
Wake On RTC Module
User Setting Hour
User Setting Minute
CAN bus Port
[Turn On Both]
6-36V
[(11.5,10.5)/(23,21)]
[Disabled]
[Disabled]
[Enable]
[Enable]
[Disable]
[RS-422]
[RS-422]
[Enable]
0
[Enable]
0
1