Hardware specifications – NEXCOM VTC 1000 User Manual

Page 16

VTC 1000 User Manual

Chapter 1: Product Introduction

Hardware Specifications

Main Chipset
• Intel

EG20T

CPU
• Intel

Atom™ E640 1.0GHz

Memory
• On board 1GB DDR2 800MHz

Expansion
• Mini PCIe socket (USB) x 1 (for 3.5G module)
• 1x Bluetooth module (optional)
• Mini PCIe socket (PCIe + USB) x 1 (for WLAN module)
• 1x default U-blox UBX-G6010 GPS module (50-channel and GALILEO) or

optional modules with Dead Reckoning or GLONASS support

I/O Interfaces - Front
• 2x LEDs for power status and SSD status
• 1x COM port (RS-232)
• 2x USB ports
• 1x RJ45 for 10/ 100/ 1000 Ethernet
• 1x SIM card socket
• 1x system reset button
• 1x Mic-In, 1x Line-Out (for WWAN voice communication)
• Power button
• 3x mounting holes SMA-type for WWAN/WLAN/BT

I/O Interfaces - Rear
• 1x DB9 COM port (2 x RS485) or (2 x RS422) or (1 x RS422 +

1x RS485) selected by BIOS setting

• 1x DB9 port, 4x GPI and (2x GPO + CAN Bus 2.0B) or (4x GPO)

selected by BIOS setting

• 1x DB15 VGA port
• 1x DC output (5V/1A, 12V/1A)
• 1x DC input via 3-pin connector
• 1x mounting holes SMA-type for GPS

Expandable Storage
• 1x SATA 2.5” SSD Bay

Power Management
• Selectable boot-up & shut-down voltage for low power protection
• HW design ready for 8-level delay time on/off at user’s self configuration
• Power on/off ignition, software detectable
• Supports S4 suspend mode ; Wake-On by RTC

G-Sensor
• ±2g Dual Axis Accelerometer