Security save & exit, Security, Save & exit – NEXCOM NDiS 167 User Manual

Page 71

NDiS 167 User Manual

Chapter 4: BIOS Setup

Security

Advanced

Boot

Security

Save & Exit

Main

→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

Set Administrator Password

Password Description

If ONLY the Administrator’s password is set,

then this only limits access to Setup and is

only asked for when entering Setup.

If ONLY the User’s password is set, then this

is a power on password and must be entered to

boot or enter Setup. In Setup the User Will

have Administrator rights.

The password length must be

in the following range:

Minimum length

Maximum

Administrator Password

User Password

Administrator Password
Select this to reconfigure the administrator’s password.

User Password
Select this to reconfigure the user’s password.

Save & Exit

Save Changes and Exit
To save the changes and reset, select this field then press . A dialog
box will appear. Confirm by selecting Yes.

Discard Changes and Reset
To exit the Setup utility without saving the changes, select this field then
press . You may be prompted to confirm again before exiting.

Load Optimized Defaults
To restore the BIOS to default settings, select this field then press . A
dialog box will appear. Confirm by selecting Yes.

Save & Exit

Advanced

Boot

Security

Save & Exit

Main

→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

Reset the system after saving

the changes.

Save Changes and Exit

Discard Changes and Reset

Load Optimized Defaults