NEXCOM NDiS 167 User Manual
Page 63
Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved.
49
NDiS 167 User Manual
Chapter 4: BIOS Setup
SATA Controller(s)
Enables or disables SATA device.
SATA Configuration
This section is used to configure the SATA drives.
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 America Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable or disable SATA Device.
SATA Controller(s)
SATA Mode Selection
Serial ATA Port 0
Software Preserve
Serial ATA Port 1
Software Preserve
[Enabled]
[IDE]
TOSHIBA MK1676 (160.0
SUPPORTED
Empty
Unknown
SATA Mode Selection
Configures the SATA as IDE, AHCI or RAID mode.
IDE
This option configures the Serial ATA drives as Parallel ATA
physical storage device.
AHCI
This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
Serial ATA Port 0 to Serial ATA Port 1
Displays information on the SATA devices detected.