NEXCOM NDiS 167 - Manual (Page 61)

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved. 47 NDiS 167 User Manual
Chapter 4: BIOS Setup
Save & Exit Advanced Boot Security Save & Exit Main
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 America Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable system to wake using
RTC alarm
► RTC Wake Settings
► ACPI Settings
► CPU Configuration
► SATA Configuration
► Graphics Configuration
► AMT Configuration
► USB Configuration
► Super IO Configuration
► H/W Monitor
► CPU PPM Configuration
Advanced
The Advanced menu allows you to configure your system for basic operation.
Some entries are defaults required by the system board, while others, if
enabled, will improve the performance of your system or let you set some
features according to your preference.
Setting incorrect field values may cause the system to
malfunction.
Save & Exit Advanced Chipset Boot Security Main
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 America Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable or disable System
wake on alarm event. When
enabled. System will wake on the
hr::min::sec specified
Wake system with Fixed Time [Disabled]
RTC Wake Settings
This section is used to enable or disable system to wake using RTC alarm.
Wake system with Fixed Time
This section is used to enable or disable system wake on alarm event. When
enabled, system will wake on the HR:MIN:SEC specified.