NEXCOM NDiS 167 User Manual

Page 41

Text mode
Original mode

NDiS 167 User Manual

Chapter 3: System Setup

3. Note how the module is keyed to the socket. Grasping the module by its
edges, align the module with the socket so that the “notch” on the module
is aligned with the “key” on the socket. The key ensures the module can be
plugged into the socket in only one direction.

Notch

Key

4. Insert the module into the socket at an approximately 30 degrees angle.
Apply firm even pressure to each end of the module until it slips down
into the socket. The contact fingers on the edge of the module will almost
completely disappear inside the socket.

The ejector tabs at the ends of the socket will automatically snap into the
locked position to hold the module in place.