NEXCOM NDiS 126 - Manual (Page 66)

Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 53 NDiS 126 User Manual
Chapter 4: BIOS Setup
SATA Controller(s)
SATA ports (0-3) Device Names if present and Enabled.
Configure SATA as
Select a configuration for SATA controller
IDE Mode
This option configures the Serial ATA drives as Parallel ATA storage devices.
AHCI Mode
This option allows the Serial ATA devices to use AHCI (Ad vanced Host
Controller Interface).
Port Speed Limit
This option configures the Port ACHI Speed Limit.
SATA Port
This option Enables or Disable the SATA Port.
SATA Port Hotplug
This option Enables or Disable the SATA Port as Hot pluggable.
Please set SATA Mode to IDE Mode before installing Windows
XP. Setting AHCI mode could not initial Windows XP installation.
IDE Configuration
This section is used to configure the IDE and SATA devices.
Save & Exit Advanced Chipset Boot Security Main
Version 2.13.1216. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 America Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
SATA ports (0-3) Device Names if
present and Enabled.
SATA Port 0
SATA Port 1
SATA Controller(s)
Configure SATA as
Port 0 Speed Limit
Port 1 Speed Limit
SATA Port 0
SATA Port 0 Hot Plug
SATA Port 1
SATA Port 1 Hot Plug
MISC Configuration for hrad disk
Not Present
Not Present
[Enable]
[AHCI]
[No Limit]
[No Limit]
[Enabled]
[Enabled]
[Enabled]
[Enabled]