beautypg.com

F: obdii m, Ppendix, Odule – NEXCOM NViS 2310 User Manual

Page 84: Etup, Ommand, Obdii module, Viox-can01 setup

background image

Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.

70

Appendix F: OBDII Module Setup and Command

NViS2310 User Manual

a

PPendIx

f: oBdII m

odule

s

etuP

and

C

ommand

OBDII Module

NViS2310 offer an option to integrate the OBDII module, VIOX-CAN01, into

NViS2310 system. The form factor of this VIOX-CAN01 is proprietary and

it can support either SAE J1939 or SAE J1708 via connection in the first

time. The maximum VIOX-CAN01 installed in NViS2310 is up to three units.

Please note they are factory option.

VIOX-CAN01 Setup

When you start connecting NViS2310 device to CAN bus device, you need

a terminal program to send and receive data. To use the terminal program,

please follow the setting below.

(1) Set the proper corresponding “COM” port and its data rate is 9600

(2) Set data bits at 8, stop bit at 1 and no parity bits.

After the setting, you will see the prompt with “>” character. This indicates

that the device is in the idle state and ready to receive characters on the

COM port.

If you do not see prompt string, please reset the device with ATR (reset)

command and then press the return key:

>ATR or >AT R (spaces are optional; and case is in-sensetive).

You can also type HEX code instead:

“41”, “54”, “5A”, “0D”

If you see strange characters instead of “>”, you may set the incorrect

baud rate. Please check baud rate. If you send the incorrect command,

the device will show a single question mark (“?”) to indicate your input is

not understood. If NViS2310 fails to link to the BUS, it will show “PLEASE

REBOOT”.

Once NViS2310 connect to BUS, it will start to try which protocol is

connected either J1939 or J1708. Once it is determined, it will only accept

the successful protocol next time unless using ATR command to reset it.

This means you can change the protocol by reset command. After the reset

command, please power off the device and turn on it again.

In case, the device cannot find correct protocol after 180 seconds, it will

enter sleeping mode for power saving.

There are several output format available for the different application

including:

(1) Simple Data by ASCII Code

(2) Raw Data

(3) Packaged Messages by ASCII or HEX code.

The default setting is Simple Data Format. The device will send messages

out after it communicates with vehicle successfully. The output format can

be changed via setting the AT command. Please refer the following section

of AT command.

This manual is related to the following products: