beautypg.com

Installing a so-dimm – NEXCOM NViS 2310 User Manual

Page 55

background image

Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.

41

Chapter 4: System Setup

NViS2310 User Manual

Installing a SO-DIMM

1. Push the ejector tabs which are at the ends of the socket outward. Then

insert the module into the socket at an approximately 30 degrees angle.

Apply firm even pressure to each end of the module until it slips down
into the socket. The contact fingers on the edge of the module will
almost completely disappear inside the socket.

Ejector tab

This manual is related to the following products: