NEXCOM NPT 1550 - Manual (Page 26)

19
ACPI Configuration
This section is used to configure the Advanced ACPI configuration.
Suspend mode
Sets the ACPI Standby State when system goes into ACPI Standby Mode.S1/PSOS: Power
on Suspend. In the S1 state, a bit more power is consumed and the fans remain active.
S3/STR: Suspend to RAM. Provides the greatest amount of power savings. While in the S3
state, the PC is silent with the monitor and fans off.
Default: [S1 (POS)]
Repost Video on S3 Resume
Set this value to allow video repost support. No: this setting prevents the video BIOS to be
initialized when coming out of the S3 state. Yes: this setting allows the video BIOS to be
initialized when coming out of the S3 state.
ACPI APIC support
The ACPI standard (Advanced Configuration and Interface power) allows the operating
system directly to check the functions of energy saving and the PnP (Plug and Play)
functionality. The ACPI functions are normally activated by the BIOS. The choices are:
Enabled and Disabled
Default:[Enabled]