NEXCOM NEX 852VL2 - Manual (Page 55)

Figure 4-10: BIOS – PnP/PCI Configurations
Reset Configuration Data
Normally, you leave this field Disabled, Select Enabled to reset Extended System Configuration Data
(ESCD) when you exit Setup if you have installed a new add-on Card and the system reconfiguration has
caused such a serious conflict that the operating system can not boot. The choices are Enabled and
Disabled.
Resources Controlled By
The Award Plug and Play BIOS has the capacity to automatically configure all of the boot and Plug and Play
compatible devices. However, this capability means absolutely nothing unless you are using a Plug and
Play operating system such as going into each of the submenus that follows this field. The choices are Auto
(ESCD), Manual.
4.13 PC Health Status
When main boards support hardware monitoring, this item lets you monitor the parameters for critical
voltages, critical temperatures, and fan speeds. These are the read only items.
After you have read the PC Health Status, press the <ESC> key to go back to the main program screen.
4.14 Load Fail-Safe Defaults
This option opens a dialog box that lets you install fail-safe defaults for all appropriate items in the whole
setup utility. Press the <Y> key and then <Enter> to install the defaults. Press the <N> key and then
<Enter> to not install the defaults.
Use this option if you have changed your system and it does not operate correctly or does not power up.
54